STARTUP PROCEDURES
IMPORTANT!
Read these step-by-step startup procedures before starting your spa. Failure to follow
any of these steps listed may result in damage to the equipment and may void the warranty.
NOTE:
Running the spa pump dry (without water running through it) could cause IMMEDIATE
damage! Be sure the following conditions exist:
The spa has been installed properly in accordance with the instructions in this manual.
All valves must be open from the spa to the spa pack. These are usually located to the left of the
pump and to the right of the equipment head. Be sure the Slide Valve T-Handles are pulled out
completely.
Slide Valve
T-Handle
Union
Check and tighten unions at each end of the heater tube.
CAUTION! DO NOT
use a wrench. These
are hand-tightened unions and over tightening may cause damage to unions and gaskets, which may
not be covered under warranty.
Clean out the spa and remove any foreign material. Gel Gloss Acrylic Polish or any type of soft paste
wax is recommended for polishing the surface of your spa. Fill spa with water (hard water is
recommended) to approximately 4 inches from the top of the spa. Simply put a garden hose directly
into the spa.
CAUTION! Be sure drain bib is closed before the water is turned on. DO NOT turn
pump on until the spa is filled to the required level. Running the pump dry may cause
IMMEDIATE damage, which will not be covered under warranty!
9
Summary of Contents for 10000/BOCA GRANDE
Page 14: ...14 14 ...
