Complete
Assembly
Breakdown
Fig. 17
Switch Cup
Plate
Coupler
VIII. Turn the power supply back on and prepare to be comfortable.
The first pull of the chain will give you high speed. The second is medium speed, and the third is low
speed. Once again will turn it off.
With the reverse switch in the down position, the fan will provide downward air movement and positive air
flow to cool you in the hot season. In the up position, air movement is upward and will bring heat trapped
at the ceiling , down around the rooms walls, warming you in the cold season.
*CAUTION - DO NOT ATTEMPT TO REVERSE THE FAN WHILE BLADES ARE IN MOTION*
Troubleshooting
IX.
Fan won't run -
Check power supply.
Reverse switch is not fully engaged.
Pin is pushed out of switch cup wire connector
Fan makes noise -
Please allow 24 hrs. running time to fully
seat bearings.
Screw(s) is(are) loose somewhere.
Ball is not seated properly in hanging bracket.
Variable speed control (dimmer) in fan circuit.
Fan wobbles -
Bracket is loose on ceiling.
Loose screw at top of fan.
Ball is not seated properly in hanging bracket.
Try switching opposing blades.
Try the blade balancing kit included.
Fig. 15
INCORRECT
CORRECT
We recommend that you retighten the blade
iron to blade screws and blade iron to motor
screws after fan has been up for 30 to 60 days.
Gulf Coast Fans, Inc. products are sold at
Dan's Fan City stores.
Our service department is always ready to
help. We stand behind our product and always
strive to satisfy our customer.
Gulf Coast Fans, Inc.
300 Dunbar Avenue
Oldsmar, Florida 34677
(813)-855-7384
VI. To avoid scratching the switch cup or damaging the motor, do not run the fan
without the blades. So, the next step is to mount the blade assemblies on the
motor. The easiest way to do this is to insert a motor screw into one hole on the
base of the blade iron; hold it in place with a screwdriver and lift blade assembly
into place. Fig. 14. Start this screw in an appropriate hole in motor. Now insert
another into the other hole and tighten both screws. Repeat this with the rest of
the blade assemblies, and retighten all of the screws.
Fig. 16
V. With the motor in place and the wires out of the way, slide the
canopy up to the hanging bracket. The canopy screw in the
bracket will come through the large end of the key slot in the
canopy. Fig. 13. Turn the canopy slightly, counter-clockwise, to
hold in place, and insert remaining canopy screw. Tighten the
screws.
FIG. 13
CANOPY
VII. You're just about done now. The switch cup is the last step, and it's simple.
Notice the wire connectors in the switch cup and on the motor. They are color
coded and notched to fit only one way. Check the pins in both connectors for
alignment as shown in Fig. 15. If they the pins are only slightly misaligned,
bundle the wires tightly behind the connector when connecting. Push the
connectors together until latch secures them together and make sure none of
the pins were pushed out. Lift the cup into place . Insert one of the screws
removed earlier and thread into switch cup plate. Insert the remaining switch
cup screws and tighten all. Fig. 16.
Gulf Coast Fans 2010 - Portions
â
1993
FIG. 14
