2
(1) Align the adjustment skateboard to the 1/4 screw
hole at the bottom of the camera and place to the
appropriate position，then tighten the screw.
1
1. Installation
Attention: Please complete the following instructions before power on the gimbal
!
As the stabilizer comes with boot self-test function, such as the stabilizer due to no load, the balance
adjustment is less than ideal, or due to the intensity adjustment does not fit and other reasons cause
the stabilizer vibration is too large, the gimbalwill automatically enter the standby mode.
Attention
Insert the batteries
Remove the handle, insert
2 pcs 18650 batteries and
tighten the screw.
Prior to use, please be sure to fill the battery.
Installation of the camera
18650
18650
1
