Customer Helpline
0333 3201989
19
NOTE:
Before using the tool, read the instruction book carefully.
Intended Use
This tool is intended for driving in and loosening screws.
BEFORE PUTTING INTO OPERATION
1. CHARGING THE BATTERY(SEE FIG A)
NOTE:
a) Do not use any charger other than that specifically provided for use with the equipment.
b) If the battery pack is very hot you must remove your battery pack from the charger and
allow time for the battery to cool down before recharging.
c) The battery in your new tool is not charged when it leaves the plant. Therefore it must
be full charged before using the first time.
d) Please charge the battery to reach full or no less than half charge before storage. If the
tool will not be used for long periods of time, charge the battery every 3-6 months.
Plug the charger plug into a suitable power outlet. Next, connect the DC plug to the
Charging Socket (6). When charging is completed, unplug the charging, disconnect the
Charger from the screwdriver. The screwdriver is ready to be used
IMPORTANT: When charging, the charger and screwdriver may become warm to the
touch, this is normal and does not indicate a problem.
WARNING:
When battery charge runs out after continuous use or exposure to
direct sunlight or heat, allow time for the tool to cool down before re-charging to
achieve the full charge.
CHARGING INDICATOR
Light
Status
red on
Charging
green on
Fully Charged
Operating Instructions
Power
outlet
Charger
plug
A
Summary of Contents for CSD36G2
Page 24: ......
