12
5.4.3. Regulator address setting
Regulator address for preset communication protocol.
RS485 network regulátor address
5.5. Regulator setting change
5.5.1. Setting with PC and TSensor software
User’s software
TSensor
provides
setting of all regulator parameters.
The program is
available free to download at web page
. Run the TSensor
program and follow
the program instructions. Regulator includes hardware write protection of internal setting, new
setting is possible to write only while:
1. during write period press „
SET
“ key – do requested setting in TSensor software, press „
SET
“
key on regulator and keep it down, then click on the button „
Save Changes
“ into TSensor
software and after end of write release „
SET
“ key, or
2. jumper placed nearby keys is closed (jumper is accessible after demounting of four screws in
the corners of the box and removing the lid ). This jumper is suitable e.g. until device
adjustment is in process and regulator is placed into calibration box and keys are not
accessible. Don’t forget to remove (open) jumper after procedure finish (restore write
protection)
TSensor software supports to make the adjustment of the regulator too. This procedure is described
at file „
Calibration manual.pdf
“ which is installed commonly with the software.
5.5.2. Setting with using regulator keys
If „Actual regulator preset” is displayed (see chapter ”
possible to enter into edit mode and edit displayed value by pressing „
SET
“ key. Then you are asked
for valid password (PASS). You can edit selected value if right password is entered. During value
editing there is range check executed and edited value is still compared with limits for corresponding
value (range). If inserted value is higher or lower then edited number is automatically changed to its
maximum / minimum value – for possible range see chapter „
at page 24.
Value can be changed with using „
▲
“ and „
▼
“ keys. Edited value is switched in “round” -9, -8, -7,
…-2, -1, 0, 1, 2, …8, 9. To edit next number digit press „
SET
“ key, for moving back to previous digit
press „
ESC
“ key. Edited value is stored by next „
SET
“ key pressing. It is possible to cancel editing
by pressing „
ESC
“ key if necessary. If valid password is once inserted right, then there is possible to
edit next items without asking for password insertion again, till “Actual regulator preset” is left (till
actual measured values are shown). With new entering into edit mode it is necessary to enter Password
again. Default password setting is preset from manufacturer to 0000, password change is possible
into „Extended setting”. During edit mode regulator still works and changes are valid immediately
after its storing – it is not necessary to restart regulator.
