730372.doc 3429
7
For replacement parts you can call the Guest Co. at 203-235-4421 or contact your local
dealer.
Replacement bulb kit
729494
Control Panel
729829-P
Lower motor
U-3135
Relay PC board (503A spotlight Base)
729978
Extension Cable Kit
729528
Safety glass lens
B-23186
Gasket for Control
729962
Base mounting gasket for Spotlight
728372
Spot/Flood Reflector
D-23127-1
Dual Station Kit
729830-P
NOTE:
THE CONTROL PANELS USED WITH GUEST MODELS 500A, 501A, OR 502A WILL
NOT
OPERATE THE MODEL 503A SPOT/FLOOD LIGHT.
Troubleshooting
Under normal use, your Guest Beamer spotlight will provide you with many years of
reliable service.
If an operational problem occurs:
Confirm that all fuses are intact
.
If a fuse
has
blown, do not replace the fuse until the
cause of the problem has been located and corrected. NEVER replace a blown fuse with a higher
value fuse.
Most problems are caused by poor wiring connections.
Confirm that all wiring
connections are accurate
and well made. Be sure that the spotlight and control are connected to a
12 volt DC power source capable of supplying 10 amps even while other equipment is operating.
(See diagram on page 5.)
If the spotlight does not move or light
, remove the 4 bolts that fasten the spotlight onto
the mounting surface and gently lift the light until you can see inside
its base . Avoid cutting any
wires. Gently inspect the base for broken connections. Examine the circuit board for loose plug
connectors, blackened components or corrosion. Replace the circuit board if it appears damaged.
If there are no loose wires or signs of water penetration, re-install the spotlight and then replace
the control pad. If there signs of water damage, return the spotlight and control to the Guest Co.
Service Department for repair, include information about how and where the spotlight was
installed.
