Hotspot Gateway Product Setup
- Quick Start Guide 1
The Guest Internet Hotspot Internet gateway products have Ethernet LAN ports
that are used to connect wireless access points, Internet café kiosk computers,
wired hotel rooms and business center computers. The Internet (WAN) ports
must be connected to the DSL or cable modem, or to a T3 or fiber circuit.
First Time Product Configuration
Connect your laptop computer to one of the LAN ports of the gateway.
Connect the Internet port to your DSL router.
Open your computer browser. Instead of your login page you will see the
page shown below. This page is the SETUP WIZARD.
The setup process has four steps. Follow the instructions to type in the
information requested on each page. Then click on the button to go to the
next page. When the setup process is completed your personalized
wireless Internet service will be ready for your guests to start using. The
setup process is shown overleaf: flip this page over to start the setup
process.
Connect your computer
Ethernet connector to the
LAN1 connector of the
gateway. Your computer
Ethernet connector should be
configured for dynamic IP or
as a DHCP client. It cannot be
used with a fixed IP.
Login to the Admin pages at any time. Connect your computer to the
gateway via an Ethernet cable to the LAN port. Then open your browser
and type in the URL:
http://aplogin.com/admin
The username is
admin
, and the password is the one that you entered
with the wizard.
When the page opens select the option you need in the menu. See the
manual for more information about configuration.
Download the product manual at: http://www.guest-internet.com/gateway
For operation the WiFi Hotspot users will
use the wireless network or kiosk
computers. Connect wireless access
points and kiosk computers to the
gateway LAN ports.
First connect the gateway as shown in the
diagram to configure it using the setup wizard.
Connect the Internet connector of the
gateway to the DSL or cable modem LAN
Ethernet connector. The DSL of cable
modem should have the LAN network
connector configured as a DNCP server.
Check with the equipment manual to verify
the LAN connector configuration.
If you wish to connect
more devices then connect
an Ethernet switch to one
of the LAN ports.
Reset to Factory Defaults
:
Connect the Ethernet cable of the WAN1 port to the computer
Ethernet port. Set the computer IP:
192.168.200.2
Open the browser at
http://192.168.200.1
The browser will open a box then enter Username:
reset
Password:
reset
The screen will show a reset button which must be clicked to reset the unit to factory default settings
Copyright © Fire4 Systems Inc., 2014. All rights reserved.
GIS-R80
LAN1 to LAN4
Default Port Configuration
WAN1 to WAN4
USE ONLY
THE POWER
SUPPLY
SHIPPED
WITH THE
UNIT TO
PREVENT
DAMAGE
DO NOT DISCONNECT
POWER DURING RESET
TO AVOID DAMAGE
Internet
DSL or Cable
Configuration
computer
WAN1 port
12 volt 3Amp
power supply for
110/220volts
Power, 12volts, 3A
