Guepard Networks GO1200ac, Manual, Page: 28 / 28

GO1200ac Manual
www.guepardnetworks.com
4
th
Trouble Shoo ng:
No. Symptoms of AP device Solu on
1 AP’s Indicator o ff Please make sure the PoE module connec on is connected right
PoE Port. And PoE adapter connect right power outlet.
2 I forget user name and password
in GUI login Press and hold the “Reset” bu on more than 15 seconds to
restore factory default
3 I cannot login the AP through
WEB management
1. Please make sure PC and AP’s IP Address are in same network
segment, then check if can Ping AP’s IP address: PC start--input
“and” in Run, then ping 192.168.188.253
2. Login again a er Restore this ceiling AP to factory default.
3. Make sure there isn’t any equipment to take IP address of
192.168.188.253 in the same network
4
.
Check LAN cable to avoid any problem, recommend do not
use unshielded twisted pair Ethernet cable.
4 I forget the AP’s SSID and
passwords
1. Login to AP’s GUI page by internet cable, then reset password
in WiFi se ng.
2. Restore to factory default
5 I can’t access to AP’s IP address
1. Check AP’s DHCP and make it enabled in Gateway mode.
2. Check the internet connec on between AP and the root
router/switch in AP and Repeater mode.
3. Or AP run in AP mode. PC should change IP matching AP’s IP
subnet.
6 I can’t access into Internet even
fi nished the se ngs of wireless
AP
1
.
If dynamic IP user, login wireless AP’s WEB
page, check Internet se ngs--WAN Se ng--Dynamic IP, fi ll in
right informa on.
2
.
If ADSL user, login wireless AP’s WEB page, check
Internet se ngs--WAN se ng--PPPOE, then input the right user
name and password
3. Please set PC’s IP address as obtain IP address
automa cally
7 How to change IP address in local
network
Click Advanced se ngs- Network - LAN se ngs- IP address se ng-
Apply
8 How to Reset Wireless AP
Press and hold the “Reset” bu on more than 15 seconds a er
power on. The Wireless AP will be restored back factory default
a er the Wireless AP restart.
28 | P a g e