GUDNORD+ 39062269974, Instruction Manual

Page: 12 / 84

12 | GB
14. Disposal and recycling
Information on packaging
The packaging materials are recyclable.
Please dispose of packaging in an envi-
ronmentally friendly manner.
Information on the German Electrical and Electronic Equip-
ment Act (ElectroG)
Electrical and electronic appliances do not belong in
household waste, but should be collected and disposed of
separately.
• Used batteries or rechargeable batteries that are not installed
permanently in the old appliance must be removed before dis-
posal. Their disposal is regulated by the battery law.
• Owners or users of electrical and electronic appliances are
obliged by law to return them after use.
• The end user bears personal responsibility for deleting his per-
sonal data from the old appliance to be disposed of.
• The symbol of the crossed-through rubbish bin means that
electrical and electronic appliances may not be disposed of in
the household rubbish.
• Electrical and electronic appliances can be handed in at the
following places at no charge:
- Public service disposal or collection points (e.g. municipal
building yards)
- Points of sale of electrical appliances (stationary and online)
provided traders are obliged to take them back or offer this
voluntarily.
- Up to three waste electrical devices per type of device,
with an edge length of no more than 25 centimetres, can
be returned free of charge to the manufacturer without prior
purchase of a new device from the manufacturer or taken to
another authorised collection point in your vicinity.
- Further supplementary take-back conditions of the manu-
facturers and distributors can be obtained from the respec-
tive customer service.
• If the manufacturer delivers a new electrical appliance to a
private household, the manufacturer can arrange for the free
collection of the old electrical appliance upon request from the
end user. Please contact the manufacturer’s customer service
for this.
• These statements only apply to appliances that are installed
and sold in the countries of the European Union and are subject
to European Directive 2012/19/EU. Different provisions may
apply to the disposal of electrical and electronic appliances in
countries outside the European Union.
When replacing, ensure that no dirt gets into the cylinder
head.
Check the fit of the spark plug.
A loose spark plug can cause damage to the engine by over-
heating.
Pulling too hard can damage the thread in the cylinder head.
The manufacturer is not responsible for the resulting damages;
the user solely bears the risk. Only use the recommended spark
plugs or identical spark plugs.
Clean the air filter (fig. 1 + 9)
1. Loosen the knurled screw (7)
2.
Remove the air filter cover (5).
3. Clean the foam pre-filter (e) a non-flammable solvent.
Attention:Do not use petrol or cleaning solvents with a low flash
point to clean the air filter element.
This could result in fire or
explosion.
4.
Squeeze the pre-filter in order to remove the solvent/soapy
water.
5. Rinse the washed filter element with clean water.
6. Allow the filter element to dry thoroughly or blow it out.
7. Attach the filter cover again and tighten the knurled screw.
If the engine is operated in very dusty environments, clean the air
filter daily or after every ten operating hours.
Never run the engine without an air filter or with a damaged air
filter.
This would allow dirt into the engine, which would result in
severe damage to the engine.
The manufacturer is not responsible for the resulting damages;
the user solely bears the risk.
Important note in the case of repairs:
When returning the device for repair, please ensure for safety rea-
sons that it is free of oil and fuel when it is sent to the service
centre.
Service information
With this product, it is necessary to note that the following parts are
subject to natural or usage-related wear, or that the following parts
are required as consumables.
Wearing parts*:
Spark plug, filter
* may not be included in the scope of supply!