GUDEL ZP 3-5 V4, Operating Manual

Page: 53 / 354

7.4.5 Setup process
This chapter describes the set-up procedure. Carefully read the procedure in-
structions. Then carry out the individual steps according to the detailed de-
scription.
Position the product as follows:
1 Position the base plates if necessary
Ü 2
56
2 Anchor the base plates if necessary
Ü 2
58
3 Set up uprights
Ü 2
59
4 Level uprights
Ü
Chapter 7.4.5.5,
2
62
5 Secure uprights against falling over
Ü
Chapter 7.4.5.6,
2
64
6 Install a beam:
6.1 Standard
Ü
Chapter 7.4.5.7,
2
64
6.2 Beam leveling kit
Ü
Chapter 7.4.5.8,
2
66
7 Connect beam
Ü 2
67
8 Straighten beam
Ü 2
68
9 Install the bumper unit
Ü 2
72
The product has been set up.
7.4.5.1 Special tools, testing and measuring instruments
Ensure that you have the following special tools, testing and measuring instru-
ments at hand:
Tool Use Item number
Sharpening stone Rubbing reference sur-
faces 0503016
Extractor Replacing rollers 10195363
Pry bar L ≥ 1500 mm Aligning upright and
beam
Machine frame spirit
level 0.1 mm/m Leveling the axis
Measurement bolt Check rack transition
Mounting aid Replacing rollers 10191451
Commissioning OPERATING MANUAL ZP 3-5 V4
72057594174110603_v5.0_
EN-US
53