Instructions for installation and first putting the
appliance into operation
Never use the appliance near flames, sparks and
flammable substances.
MINIMUM DISTANCE OF 2 M TO BE NECESSARILY
KEPT!!!
Fitting the appliance to the gas bottle (pic. 2-5)
Step 1
Make sure all components are standing safely. Make sure
the socket heater, gas hose and gas bottle are safe.
Step 2
To fix the stand (3) on the bottle, use the clamping screw
(4).
Step 3
Screw the pressure controller (11) and the gas hose (10)
on the gas bottle valve.
Step 4
Use the wing nut (8) and the toothed disk (9) to put the
heater to the required position and fix it on the stand (3).
Step 5
Screw the other end of the gas hose (10) to the safety
valve (7).
Step 6
Make sure all the screwing is tight.
Before putting the appliance into operation, check
necessarily the screw caps for any gas leak using a
leak detection spray or lye soap. Retighten them if
necessary.
Putting the appliance into operation
Step 1
Put the assembled appliance to a level and stable position.
Step 2
Open the valve on the gas bottle. Make sure the gas line
and the screwings are gas tight and there is no leak.
Step 3
Prepare the spark gun.
Step 4
Press the gas volume controller in the middle. Ignite the
radiant heater immediately using the spark gun (risk of
ignition) while the gas volume controller is kept pressed.
To ignite the gas-air mixture, the gas volume controller
must be pressed, even several times if necessary.
Step 5
After igniting the gas-air mixture, keep the gas volume
controller pressed for app. 10 to 20 more seconds. Then
release it slowly and check whether the socket heater is
working continuously.
Step 6
The power may be reduced or increased by turning the
gas volume controller. The adjustment space is limited by
stops.
Before putting the appliance into operation, check
necessarily the screw caps for any gas leak using a
leak detection spray or lye soap. Retighten them if
necessary.
Changing the gas bottle
•
Whenever being outdoors alone, keep distance
from the flames or sources of fire and proceed
as follows!
•
Close the gas bottle valve.
•
Unscrew the pressure reducing valve
(11)
.
•
Unscrew the clamping screw
(4)
and remove the
appliance.
•
Find out if there is pressure controller sealing in
place.
•
Put the appliance on a new gas bottle and
continue as specified in “Instructions for
installation and putting the appliance into
operation”.
Marking
Product safety:
Product corresponds to
applicable EU standards
Prohibitions:
No fire!
No operation in enclosed
spaces!
No smoking!
Warning:
Warning/Caution
Warning against hot
surface
Bystanders must keep safety
distance
To be used outdoors only
and necessarily protected
against moisture.
Commands:
General command sign
Please read the Operating
Instructions before using
the machine
Secure the gas bottle against
turnover
Environment protection:
Dispose waste professionally
so as not harm the
environment.
Packing cardboard material
may be delivered to
collecting centres for
recycling.
Any defective and/or disposed
electric or electronic devices
must be delivered to
respective collection centres.
Package:
Protect against moisture
This side up
Interseroh-Recycling
9
