12
13
•
To track a new OLAS transmitter it needs to be switched on and brought into ‘Close’ range of the
Guardian hub. This is around 0.5 metres. If it is not automatically tracked move it closer to the
Guardian hub.
•
Once the OLAS transmitter is automatically tracked the Guardian hub will beep twice.
•
Open the OLAS mobile app.
•
Select the Guardian from the device selection page.
•
All OLAS transmitters that are being tracked will be indicated on the home page.
•
Use the homepage to check the battery life of the OLAS transmitters.
•
Customise the OLAS transmitters name.
•
Check OLAS tags battery status.
•
Enable/disable cut-off switch for individual OLAS transmitters.
•
Pause OLAS transmitters.
•
Pause all tracking.
•
Press the control switch once.
•
The number of tracked OLAS transmitters is indicated with a single beep sound signal and one
green flash per transmitter. Up to 25 transmitters can be tracked.
•
Connect the OLAS mobile app to the Guardian.
•
Navigate to the home screen.
•
Any non-tracked OLAS transmitters within range of the Guardian will appear on the home screen
greyed out.
•
Click on the right-hand side of the tag and select track.
•
The Guardian hub will beep twice to indicate a tag has been tracked.
•
To track a previously tracked OLAS transmitter it needs to be switched on and brought into ‘Near’
proximity which is around 3 metres away. If it is not automatically tracked move it closer to the
Guardian hub.
•
When the OLAS transmitter is automatically tracked the Guardian hub will beep twice.
3. TRACKING A NEW OLAS TRANSMITTER
4. TRACKING A PREVIOUSLY TRACKED OLAS TRANSMITTER
5. TRACKING AN OLAS TRANSMITTER USING THE OLAS MOBILE APP
6. CHECKING LOGGED OLAS TRANSMITTERS (without the OLAS mobile app)
7. CHECKING LOGGED OLAS TRANSMITTERS (with the OLAS mobile app)
8. OLAS MOBILE APP FEATURES (basic)
9. PAUSE TRACKING
10. SWITCHING OFF THE GUARDIAN
11. STOP TRACKING AN OLAS TRANSMITTER (without the OLAS mobile app)
12. STOP TRACKING OLAS TRANSMITTER (with the OLAS mobile app)
•
Press the control switch for 2 seconds, release the control switch after a single beep.
•
When in Paused state the control switch will flash green for 3 seconds ON/ 3 seconds OFF followed by
a single beep sound signal.
•
Press the control switch once to restart tracking.
NOTE: if you have removed an OLAS transmitter whilst the Guardian is in paused state it will beep 3 times and
remain in the Paused state.
•
The OLAS T2 can be adjusted using the OLAS mobile app so that it either cuts the engine and
triggers the alarm when it is switched off (default) or it disconnects silently.
NOTE: if the OLAS T2 is allocated as a Smart Key it will cut the engine and activate Smart Lock.
•
To remove any OLAS transmitter without using the OLAS app the Guardian will need to be switched
off.
•
Once the Guardian is switched off, switch off the transmitters you wish to stop tracking. The
Guardian will ‘forget’ these devices.
•
Switch the Guardian back on and it will track those OLAS transmitters that are still switched on and
within range.
•
Open the OLAS mobile app.
•
Select the Guardian from the device selection page.
•
All OLAS transmitters that are being tracked will be indicated on the home page.
•
Click on the right hand of the OLAS transmitter box to cycle it though the different operating states.
Once it is in Paused state and it appears greyed out then the OLAS transmitter can be switched off
and it will be removed from Tracking without activating an alert.
•
The Guardian can be switched off at any point by pressing the control switch for 4 seconds.
•
The control switch will illuminate red with a long beep before switching off.
13. LOW BATTERY ALERT
•
A low battery alert will be initiated by the Guardian when an OLAS tag’s battery level goes below
20%.
•
The alert is indicated by a red flash every 10 seconds on the control switch and the Guardian Hub.
•
The alert will remain until the battery is charged (OLAS T2) or changed (OLAS Tag).
•
You can check which OLAS tag has low battery using the OLAS app.
•
Once you have located the tag you can:
a. Pause the Guardian, charge or change the battery and restart tracking.
b. If the OLAS tags battery is below 10% the Guardian hub will start to beep once every 5 minutes.
c. Switch off the Guardian, switch off the OLAS tag and then restart the Guardian.
d. Pause the OLAS tag in the OLAS mobile app and then switch off the OLAS tag.
Summary of Contents for EXPOSURE LAS
Page 1: ...PUG2...
