4
Using Your Remote Control
Arming the Security System
To arm the system, exit the vehicle, close all doors, then press the LOCK button on the remote control.
The system will flash the parking lights 2 times, indicating the system is armed, has locked the doors
(if equipped and connected) and activated the starter disable feature. The status indicator (red warning
light) will blink steadily, once per second.
Pre-arm Mode
If the system sounds 1 time and the parking lights flash only 1 time, this indicates that the vehicle’s
interior light is on or an entrance is left open. Check to see that all doors hood and trunk are closed
properly. Once all entrances are secured (and the interior light is off), this system will sound/flash
again. The system is now fully armed. (If the entrance is not secured within 4 minutes, the system will
arm and ignore the unsecured entrance until it is closed.)
Disarming the Security System
To disarm the system press the UNLOCK button. The system will flash the parking lights 1 time, and
the doors will unlock (if equipped and connected).
Two Stage Door Unlock (Optional)
If this feature is enabled on your system, pressing the UNLOCK button one time on the remote control
will unlock only the driver’s door. Press UNLOCK again to unlock the remaining doors.
Disabling/Enabling Confirmation Chirps
This feature must be turned ON or OFF in system programming, see your installing dealer for details.
Using the Progressive Car Finder Feature
Press the CAR FIND/PANIC button on the remote control to locate your vehicle. The system will sound
5 times at low volume increasing in volume each of 3 times the button is pressed.
Using the Personal Protection Alarm (Panic)
Press and hold the CAR FIND/PANIC button on the remote control for 2 seconds to activate the
personal protection alarm. The system will sound for 30 seconds. Pressing any button on the remote
control will turn the personal protection alarm off.
Activating the Trunk Release Feature (Optional)
If this feature is enabled on your system, pressing and holding the UNLOCK button on the remote
control for 2 seconds will open the vehicle’s trunk or hatch.
*Throughout this manual, ‘press’ refers to pressing for less than 1 second; ‘press and hold’ refers to pressing for more
than 2 seconds.
Summary of Contents for CPL 100
Page 9: ...9 ...
