Guardian Telecom Inc.
Installation and Operation
ACR/ACT-VoIP Series Telephones
8.5. RESET Switch
When the Telephone is operational and linked to the network use the Reset Test Function Management
(RESET)
switch (Figure 9), on the Telephone board to announce, the Telephone’s IP Address, and test that
the audio is working (see Section 8.5.1). The message will come through the handset receiver.
Figure 9 - RESET Switch
8.5.1.
Announcing the IP Address
To announce a telephone’s current IP address:
1. Press and release the RESET switch (SW1). Do not hold more than five seconds.
Note
The telephone will use DHCP to obtain the new IP address (DHCP-assigned address or
default to 10.10.10.10 if a DHCP server is not present).
Note
Pressing and holding the RESET switch for longer than five seconds will restore the
telephone to the factory default settings.
8.5.2.
Restore the Factory Default Settings
When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Note:
Each Telephone is delivered with factory set default values.
To set the factory default settings:
1. Press and hold the
RESET
switch (SW1) for more than five seconds.
2. The telephone announces that it is restoring the factory default settings.
Note
The telephone will use DHCP to obtain the new IP address (DHCP-assigned address or
default to 10.10.10.10 if a DHCP server is not present).
8.6. Adjust the Volume
The volume can be adjusted through the Device Configuration Page.
Page 15