4
1.3 KEYPAD REMOTE LED FUNCTIONS
The keypad remote LED (if fitted) will display the following information.
KEYPAD LED CONDITION
PANEL STATUS
ON
PANEL SET
OFF
PANEL UNSET
FLASHING ON/OFF
ALARM CONDITION
If the keypad enters standby mode, then the LED will also enter standby mode. However,
any circuit or keypad activation will return the LED to the correct condition.
1.4 THE PANEL’S INTERNAL SPEAKER (If fitted)
This speaker sounds when:
1.
The sounder is on.
2.
When a chime circuit is alarmed during unset mode.
3.
During entry or exit delays.
4.
When the tamper circuit is alarmed.
2. HOW TO SET THE PANEL
The panel may be set into either of the following modes:
1.
FULL SET
when leaving home.
2.
PART SET
when remaining at home.
2.1 FULL SET
To FULL SET the panel:
1.
Verify that the READY led is on.
2. Press
the
#
key and enter your 4 digit user code. (The default code is 1234). If
you enter an incorrect value press the
#
key and re-enter your code. (If your
installer has enabled the quick set feature, you can also set the system by
depressing the
1
key for 2 seconds until the keypad beeps).
3.
The READY led will extinguish, and the buzzer will sound on/off for the
duration of the exit delay. The setting process has started.
4.
Leave immediately only via the designated entry route and exit/entry circuits.
The circuit status will be indicated for the duration of the exit delay.
