29
Problem
Cause
Help
Red LED on
• Lock overload
• Check whether the lock is
mechanically blocked
(see point "Lock does not
unlock")
• Cylinder cam not in removal
position (see fig. 1)
• Remove the key
To reset, fully retract the latchbolt 3x from the "locked position"
via the locking cylinder.
Overload during daytime release: perform complete motor-
driven unlocking operation 1x via control signal followed by full
retraction of the latchbolt 3x from the "locked position" via the
locking cylinder.
8.
Maintenance
The gear unit is lubricated for life and is therefore maintenance-free.
Lightly grease the latchbolt head 1x annually.
9.
Disposal
The motor-driven lock must be disposed of as electronic waste at special waste disposal sites.
The motor-driven lock should not be disposed of as domestic waste!
Packaging must be disposed of separately.
NOTE
