GTV 172485, Owner'S Manual

Page: 12 / 20

12
INSTALLING ACCESSORIES
All accessories are installed on the oscillating
tool in a similar manner. For the purposes of
describing the accessory installation, the half
circle blade is used.
DANGER:
Always remove the plug from
the power source before installing or
removing accessories or sandpaper. Failing
to remove the plug from the power source
may result in the tool accidentally being
started and causing serious injury to the
operator.
1.
Remove the screw (1) and washer (2) from
the accessory holder (3) by turning the
screw counter clockwise. Use the 5 mm
Hex key (4) if the screw is too tight to be
removed by hand (Fig. 1).
NOTES:
a) For " open back " accessories
(Fig. 1a), the blade screw does not have to
be removed. Simply loosen the blade
screw sufficiently to allow the accessory
mount to slide between the washer and the
accessory holder.
b) For " closed back " accessories
(Fig. 1b), the blade screw and washer must
be completely removed from the tool.
2.
Place the blade (5) on the accessory
holder (Fig. 2).
NOTES:
a) Make sure the alignment holes (6) in the
blade fit over the alignment pins (7) in the
accessory holder and the printed side of
the blade is facing the tool.
b) The blade can be mounted at various
angles left or right of center if required.
3.
Thread the screw (1) through the washer
(2) and the blade and into the accessory
holder threaded hole (8).
4. Turn the screw clockwise until it is finger
tight.
NOTES:
a)
Check to make sure the convex curve of
the washer (9) is facing the head of the
screw and the slots in the edge of the
washer fit over the alignment pins in the
accessory holder.
b)
Make sure the alignment holes in the blade
are still mated with the alignment pins in
the accessory holder.
5.
Firmly tighten the screw with the 5 mm hex
key.
NOTE: Check to make sure the holes in the
blade are still mated with the alignment pins on
the accessory holder after the screw is fully
tightened.
ASSEMBLY AND OPERATING
!
Fig. 1b
Fig. 1
Fig. 2
Fig. 1a