Page 43
Issue 07/2011
Installation of generator
Installation of generators of model 160
Important
►
Do not attach any third party parts to
the mounting profiles on the generator
housing.
3.6.2
Minimum clearances and cooling provisions
y
The generator needs sufficient ventilation for cooling. The cooling air is
drawn through the cooling profiles by the fan wheel on the rear side of the
generator and across the housing, towards the front side.
y
Ensure adequate air feed and exhaust openings.
y
Comply with the following minimum clearances and note the regulations
for cooling.
Minimum clearances
When installing, respect the following minimum
clearances from fixed parts or walls.
ð
also adjacent figures:
y
Both sides and above: a = 100 mm
y
Front: b = 300 mm
y
Rear : c = 200 mm
bb
a
a
a
Summary of Contents for DWG (BL) 13/7-2 ZE
Page 87: ...Page 87 Issue 07 2011...
