GTS BG 132, Installation And Operating Manual

Page: 58 / 128

Sy
nch
ro
no
us g
en
er
at
or
s o
f s
er
ie
s D
G
G
, D
W
G a
nd W
G
Issue 05/2013 Page 58
Installation of generator
Installation of dual-bearing generators (BG 132)
Assembly
>
Apply Loctite to the screw thread and place a toothed washer [4b]
underneath the screw head.
>
Place toothed washers [2b] underneath the nuts.
>
Place the flange [1] onto the generator and secure with four screws [4a]
and nuts [3a] to a tightening torque of 47 Nm.
>
Place the collar [2] and clamp securely with two screws.
>
Mount the coupling plate [5] on the shaft at the generator and prevent
it from twisting on the shaft with a key. Follow the manufacturer's
instructions when assembling the coupling plate.
>
Secure the drive side of the coupling [6] to the drive and insert it into the
coupling plate. If necessary, while inserting, twist slightly until the gearing
locks. Follow the coupling and motor manufacturer's instructions when
assembling the coupling plate.
>
Secure the flange [1] to the drive unit. When carrying out the attachment,
follow the instructions of the motor manufacturer.
1
2
3b
3a
4x
4x
4a
4b
5
6
4a M10 x 40 DIN 912
4b SKS 10
3a M10 DIN 985
3b A10 DIN 125
Fig. 17 Assembly of flange mount
(dual-bearing, BG 132 model with standard bearing plate)