GTS BG 132, Installation And Operating Manual

Page: 109 / 128

Page 109 Issue 05/2013
Disassembly
Disassembly of single-bearing generators
>
Remove the generator front bearing plate that is still attached to drive
motor.
To do so, unscrew the four screws [3] (Figure 36) and remove the bearing
plate [4] .
>
Attach the front bearing plate [4] to the generator.
>
Unscrew the grub screw [1] (Figure 37) from the shaft of the drive motor
with a hexagon socket wrench.
>
Remove the special hexagon nut [2] .
>
Attach the fan wheel [3] and the cover [4] again.
>
Secure the fan wheel with a key (against twisting) and a saw ring on the
shaft.
1
2
3
4
Fig. 35 Disassembly of brushless single-bearing generators (1)