DotSurfer
j. Insert the DotSurfer installation CD to the CD-ROM drive.
k. Enter
D:\WinNT
where D: is the driver letter of the CD-ROM drive. Click
OK
.
l. Select
the
GTRAN DotSurfer 153K Wireless Modem
and click
Next
.
m. Select the Preferred COM Port recorded from step (e), and click
Next
.
n. During installation, Windows may ask you to insert the DotSurfer installation CD again. Click
OK.
During the file copy stage, Windows may ask for the location of the driver file. Click
Browse
, Open and
OK
.
o. Click
Finish
p. On
the
Modem Properties
screen, click
Close
.
q. If the next screen is the
Card Management
screen, click
OK
to close and exit the
CardWizard
application. Skip the following steps and go to Remote Access Server
Installation procedures.
r. On
the
Modem Setup
screen, click
Yes
to reconfigure the Dialup Networking.
s. On
the
Remote Access Setup
screen, select
GTRAN DotSurfer 153K Wireless Modem,
and click
Continue.
t. On
the
Network Settings Change
screen, click
Yes
to reboot your computer.
2.2.3 Remote Access Server (RAS) Installation - if not already installed
a. Verify that RAS is installed. Select
Start-> Settings-> Control Panel.
b. Launch
Network
from the
Control Panel.
c. Select
the
Service
tab.
d. Check
if
Remote Access Service
is already in the list.
e. If yes, click
Close
to exit the RAS installation and continue the DotSurfer applications
installation.
f. If not, click
Add.
g. Select
Remote Access Service
and click
OK
. Insert
Windows NT CD
to finish file copying.
h. On
the
Add RAS Device
screen, select
GTRAN DotSurfer 153K Modem
, and click
OK.
i. On
the
Remote Access Setup
screen, click
Continue.
j. On
the
Network
screen, click
Close
on the next two screens.
k. Click
Yes
to reboot your computer.
7
