20
Step 2
Make sure the control box power switch is in the
OFF
position. The ON/OFF Switch is located on the bottom of
the control box. Remove the control box cover and slide
the battery into position with its terminals to the
RIGHT
(
see illustration
). Connect the
BLACK
battery wire to the
NEGATIVE
(
–
) battery terminal. Connect the
RED
battery
wire to the
POSITIVE
(
+
) terminal.
Pay close attention to
the color of the wires. If the wires are connected incorrectly,
the control board will be damaged
.
NEVER
insert the
battery with the terminals to the left.
Step 3
Strip approximately 3/16" of insulation from each
wire of the power cable. Twist each exposed wire
tightly (there are seven [7] wires inside the power cable
sheath). Loosen sealing nut on strain relief hub at
bottom of control box. Insert power cable into control
box through strain relief. Thread approximately 6"
of the power cable into the control box and retighten
sealing nut until the power cable locks into place.
Step 1
Mount the control box using the screws (
provided
) or another
secure mounting method. The control box must be mounted at
least
3 feet above the ground
to protect it from rain splash,
snow, etc., and at least
3 feet from an AC power source to
prevent electrical interference
.
RED wire to POSITIVE (
+
) terminal
BLACK wire to NEGATIVE (
–
) terminal
RED
BLACK
MIN
MAX
12 V Battery (Included)
Space for optional
second 12 Volt battery
(see Accessory Catalog)
Battery wires for
optional second battery.
RECEIVER
25
FUSE
BATT+
BATT-
1
2
3
4
O
N
D
IP
STATUS
LEARN RMT
RECEIVER
LEARN
MAST LIMIT
LEARN
SLV LIMIT
S3
S4
ALM
S2
OFF
SOFT START OFF
WARNING OFF
OPEN PULL
SLV OPEN DLY.
MODE1 OFF
MODE2 OFF
ON
ON
PUSH
SIMULT.
ON
ON
120
MASTER INPUTS
SOLAR
or
18 VAC
SLAVE INPUTS
LOCK
GTO
AUX
GTO
TRANSF
LOCK
PWR
AUX
RLY
POWER
INPUTS
CONTROL
OUTPUTS
MASTER CABLE
SLAVE CABLE
CONTROL INPUTS
AUTO CLOSE TIME
STALL FORCE
Master Power Cable
Slave Power Cable
Strain Relief
Use mounting
holes and screws
provided to mount
control box to a
secure surface.
RECEIVER
25
FUSE
BATT+
BATT-
1
2
3
4
RECEIVER
MASTER INPUTS
SOLAR
18 VAC
SLAVE INPUTS
LOCK
GTO
AUX
GTO
LOCK
AUX
RLY
POWER
INPUTS
CONTROL
OUTPUTS
MASTER CABLE
SLAVE CABLE
CONTROL INPUTS
Sealing Nut
Hub
Lock Nut
Strain Relief
NOTE:
The battery that came with your GTO PRO®,
MUST
be placed in the top (horizontal) battery slot
with the terminals on the
RIGHT
. The extra (vertical)
battery slot is for an optional second battery. A second
battery is recommended for solar and/or high traffic
applications.
Mounting the Control Box
Single Battery
Installed Horizontally
with terminals on the right.
Dual Batteries
Installed Vertically
with terminals on bottom.
