6
7
The contents of all material available on this installation manual are copyrighted by Gates That Open, LLC (“GTO”), unless otherwise indicated. All rights are reserved by GTO,
and content may not be reproduced, downloaded, disseminated, published, or transferred in any form or by any means, except with the prior, written permission of GTO.
Any reprinting of GTO publications is by permission only. Copyright infringement is a violation of federal law.
GTO®, GTO/PRO®, Mighty Mule® are registered trademarks of GTO Professional Access Systems™ is a trademark of GTO, and are the exclusive property of GTO.
All rights are reserved by GTO, and these marks may not be used, in any for without the prior, written permission of GTO.
Normal Keypad Operation:
• If the user enters a 4-digit code that is matched to one of the 25 stored codes. The STATUS light should blink rapidly
indicating that it is sending command to operator.
• No more than 20 key presses are allowed to obtain the 4-digit entry code.
Example:
1234 is one of the codes stored in one of the memory location.
The user can enter “x1234” or “xxxxxxxxxxxxxxxx1234” and the gate should be activated (x is any key). If more than
20 key presses is entered without matching one of the codes then the unit’s STATUS light should be flashing rapidly
and no entry will be accepted for the next 40 seconds. The user must not enter any code for at least 40 seconds before
the unit returns to normal operation; otherwise it remains in this “lock-down” mode. Once the user enters a matched
code, any subsequent key press within the next 40 seconds will cause the keypad to send command to gate opener.
Keying Indication Summary:
Keying Error Alert Indication
Keying accepted confirmation Indication
Master Code Setting
Speaker: continuous Beep for 2 seconds
Speaker: Beep – Beep – Beep
STATUS light: rapid flashing
STATUS light: no light, no flashing
Permanent Entry Code
Speaker: continuous Beep for 2 seconds
Speaker: Beep – Beep – Beep
STATUS light: rapid flashing
STATUS light: no light, no flashing
Temporary Entry Code
Speaker: continuous Beep for 2 seconds
Speaker: Beep – Beep – Beep
Setting
STATUS light: rapid flashing
STATUS light: no light, no flashing
Entry Code Matching
Speaker: continuous Beep for 2 seconds
Speaker: Beep – Beep – Beep
(after non-matching 20 keying)
STATUS light: rapid flashing
STATUS light: no light, no flashing
