3
5.
Charging jack
Contacts for charging the headset battery.
N/A
6.
Magic Switch
Choose which line to use or make a pairing.
8
Preparing your BTH-101
Charging the batteries and talk time
Before using it for the first time you will need to plug in an adaptor jack and charge it fully. (The headset
can be either ON or OFF).
While charging
：
1.
The indication light (red) on the headset is lit and remains lit until the headset is fully charged. The
indication light goes off while charging is completed.
2.
It takes approximately 2 hours for a fill charging then the indication light goes off
A full charging provides up to 4 hours of talk time or up to 100 hours of standby time. BTH-101’s
batteries do not need to be completely used before charging.
Low Battery Warning :
The headset needs to be recharged when indication light flashes red. Once the
low battery warning starts, you have approximately 3 to 5 minutes of remaining talk time.
Turning your headset ON and OFF
To turn your BTH-100 on
：
1. Ensure that the AC Adapter is not plugged in.
2. Press the “Talk” button firmly,
3.
The indication light will flash every 3 seconds while the headset is turned on. The headset is now
in ‘standby’ mode and ready for use.
To turn your BTH-101 off
：
1.
Press and hold
the “Talk” button firmly for at least 3 seconds until the indication light emits a very
short burst of flashes.
2.
Without delay, release the button.
The headset is now turned off and no indication light activity in this mode. You will need to wait for 5
seconds before turning it on again. As long as you are recharging your headset regularly, you do not
need to turn your headset off after using it – you only need to ‘end the call’ (see
Ending a call
)
Pairing the headset and multi-adapter
‘Pairing’ creates a wireless link between two Bluetooth devices such as headset and mobile phone.
1.
Ensure that the AC power adapter is not plugged in.
2.
Ensure that the headset is off.
3.
Put the Magic switch to the assigned line.
4.
Press and hold the “Talk” button about 3 seconds. When the indication light flashes red and green
each time after another, it is mean that you are in pairing mode. Then you can release the button.
5.
The indication light will resume to the standby mode (flashing green every 3 seconds) after a short
