Gtech EB05, Operating Manual

Page: 71 / 124

ENGLISH
71
Assembly
Make sure that you follow all of the instructions in this manual carefully to assemble your eBike
correctly before use.
We recommend that you build your eBike on a large, flat and soft surface. You may need to put
something down on the surface to stop your eBike from getting scratched.
Carefully remove all of the packaging and ties from your eBike, as well as the 4 black plastic
wheel protectors and fork spacer. Take care not to damage or scratch the bike.
Check that you have all of the correct parts before you start to assemble your eBike. See page 67.
For more information about the names and locations of the different parts of your eBike see page 68.
Make sure that the battery is removed from the bike before fitting any parts.
Make sure that all screws are tightened securely before using your eBike.
For the correct tightening torques see page 121.
Setting the handlebar stem to the correct position ..............................72
Attaching the handlebars ....................................................................73
Secure the brake cable .......................................................................75
Assembling the seat post to the saddle ..............................................76
Attaching the saddle / seat post to the bike ........................................77
Fitting the front wheel .........................................................................78
Aligning the brakes .............................................................................81
Fitting the pedals ................................................................................82
Fitting the reflectors ............................................................................83
Setting the saddle height ....................................................................85
Adjusting the saddle height .................................................................86
Adjusting the saddle travel and angle ..................................................87
Adjusting and setting the forks ............................................................89
Attaching the battery ..........................................................................90
Removing the battery .........................................................................90
Attaching the front mudguard .............................................................91
Attaching the rear mudguard ..............................................................92
You will need to use your Gtech tool for the
following instructions and throughout the manual.
The Gtech tool is located in the bottom of your
battery and can also be stored here when the
battery is attached to the bike.
Storing the Gtech tool