D-9105RExd
Digital Flame Proof Reflective Beam Detector
Installation and Operation Manual
The Intelligent Solution
16
2.
Setting Address Code
The detector offers address code programming for field application.
Refer to operation below:
(1) Enter I
2
C programming code, and the screen is a “0”.
(2) Input address code for programming (1~242).
(3) Press
Program
to start programming. “P”will be shown when
successful, otherwise an “E”will be shown.
(4) If programming is successful, press
Clear
, the screen will show a
“
0”, and you can go on with further operations.
(5) If programming fails, press
Clear
, the screen will show a “
0”, input
address code once again.
3.
Setting Sensitivity Level
The hand held programmer can set two sensitivity levels to the
detector. 2 is sensitivity one, and 3 is sensitivity two, as detailed
below:
(1) Enter I
2
C programming mode of hand held programmer, and the
screen shows a “
0”.
(2) Input unlock password, press
Clear
, and open the lock.
(3) Press
Function
then the figure “
3”, the screen shows a “
－
”
.
(4) Input sensitivity level to be set, and press
Program
to begin
programming. The screen will show a “
P” if programming is
successful, otherwise it will show an “E”
.
(5)
Clear
pressed, the screen shows “
0”, and you can go on with
further operations.
4.
Setting the Device Type
You can also set the device type of the detector through a programmer,
as detailed below:
(1) Enter I
2
C mode of the programmer, and the screen shows
“0”.
(2) Input unlock password, press
Clear,
and open the lock.
Summary of Contents for D-9105RExd
Page 1: ......
