GSS HDTV 1000 T, Assembly Instructions Manual

Page: 37 / 48

- 37 - HDTV 1000 T / HDTV 1001 T
Setting the transmitter identification
At terrestrial transmission an identification is referred to each COFDM modu-
lated transmitter. When COFDM modulated signals are fed into cable net-
works this identification is not necessary usually. If receiving problems should
occur you must refer a transmitter identification (CELL ID) to each output chan-
nel and switch ” on ” the transmitter identification.
Bx 4A
CELL 0x0000 COFDM TPS
off
Ê UÊ 1ÃiÊÌ iÊ buttons to position the cursor under the digit of the hexadeci-
mal number to be set.
Ê U Press to set the respective digit of the hexadecimal number.
Ê UÊ ,i«i>ÌÊÌ iÊ«ÀœVi`ÕÀiÊLÞÊÌ iʵÕ>˜ÌˆÌÞʜvÊÌ iÊ`ˆ}ˆÌÃÊ̜ÊLiÊÃiÌ°
Ê UÊ 1Ș}ÊÌ iÊ button place the cursor under ” off ” and switch ” on ” the trans-
mitter identification using the buttons.
—> By pressing the button you return to the hexadecimal number setting.
Ê UÊ *ÀiÃÃÊÌ iÊ button.
—> The “Stuffing” – “ STUFFING ” menu is activated.
Stuffing
This menu shows the output data rate defined using the COFDM settings and
the current output data rate.
Bx 4A
34363 (32502)
STUFFING
Number 1 Number 2
34363 (= “Number 1”): Maximum gross output data rate
( 32502 ) (= “Number 2”): The current measured gross output data rate.
Ê vÊ Ì iÊ ÃÌ>̈œ˜Ê vˆÌiÀÊ ˆÃÊ ÃiÌÊ VœÀÀiV̏Þ]Ê Ì ˆÃÊ Û>ÕiÊ ˆÃÊ œÜiÀÊ Ì >˜Ê Ì iÊ Û>ÕiÊ œvÊ Ì iÊ
º ՓLiÀÊ£»°Ê/ iÊÛ>ÕiÊvÕVÌÕ>ÌiÃ]ÊȘViÊÌ iÊ`>Ì>ÊÀ>ÌiÃʜvʈ˜`ˆÛˆ`Õ>ÊÃÌ>̈œ˜ÃÊ>ÀiÊ
dynamically modified by the broadcasters.
—> “Number 2” is not displayed in the channel strips “ A ” or “ B ” at the set-
tings “ OUTROUTE 1=>ASI ASI=>MA ” or “ 2=>ASI ASI=>MB »]ÊvœÀÊ
the data rate of the ASI input signal cannot be measured. The ASI
input signal therefore must be built in such a way so that the output
data rate (“Number 1”) is not exceeded.