GSS HDTV 1000 MPTS, Assembly Instructions Manual, Page: 33 / 46

- 33 - - 33 -
If the input signal path “ A+B+ASI=1 ASI=2 ” is selected the
station filter of channel strip “
B
” is used in the channel
strip “ A ”. Therefore perform the settings for channel strip “ B ”
according to the pages 29 … 31 (LNB oscillator frequency,
input symbol rate, input frequency) before activating the “Set-
ting the station filter” – “
PROGRAM
” menu.
If the input signal path “ A+ASI=1 B+ASI=2 ” is selected the
channel strips can be programmed one after the other.
• Press the button.
—> The “Setting the station filter” – “
PROGRAM
” menu is
activated.
Setting the station filter
The default setting for the station filter is “ off ”. In this menu
you define the services received to be transmitted. If services
are activated the output data rate increases.
If the station filter is switched off (factory default) all services
of the transport stream passes the station filter. As soon as
the station filter is activated services can be added to the
transport stream selectively.
The figure of the menu below is dependent on the setting of
the “Selecting the input signal path”
”INROUTE” menu
(page 23).
The programming procedure shown below corresponds to
the setting ”
A+B+ASI = 1 ASI = 2 ”.
With this setting the transport stream of channel strip “ B ” is
routed to the transport stream of channel strip “ A ” and there-
fore cannot be set in channel strip “ B ”. Programming channel
strip “ B ” the transport stream coming from the ASI input can
be processed only.