GSM Activate 4G-SWV-V10, Manual

Page: 5 / 7

Page 5
How to use the Multi Function Switch
Call Mode: Relay 1 only
Using your mobile phone dial the simcard number. You will hear 1 ring tone. The unit will
automatically hang up. This will prevent any call charges. Only relay 1 can be used for calling.
The relay will then turn ON and remain on. You will receive the relay state report
REL1 ON REL2 OFF
To turn the relay OFF just ring the simcard number again. You will receive the relay state report
REL1 OFF REL2 OFF
PLEASE NOTE - Calling in using 4G can currently be inconsistent due to several factors such as,
signal strength and voice over LTE (4G calling) being available on simcards and phones etc. If you
experience unreliability on 4G please boot the unit up using either 2G or 3G depending on which
has the better signal strength.
The unit will reply and let you know the state of both relays, you can turn the reply off by using the
command
# TEXT = OFF # Turns OFF the relay state report
# TEXT = ON # Turns ON the relay state report
The default setting configuration is set to relay state report on
Text Mode: Relay 1 & 2
By texting the unit you can turn relay 1 & 2 on or off individually. Below are examples of how to do
this.
# REL1 = ON # This will turn on relay 1
# REL1 = OFF # This will turn off relay
# REL2 = ON # This will turn on relay 2
# REL2 = OFF # This will turn off relay 2
It is possible to pulse relay 1 & 2 for a period of 10 seconds you will need to send a text as follows
# PULSE = REL1 # This will turn on relay 1 for 10 seconds only.
# PULSE = REL2 # This will turn on relay 2 for 10 seconds only.
Timer Mode: Relay 2 only
It is possible to turn relay 2 ON for a period of time 1 minute to a maximum 999 minutes. Send the
following command followed by the number of minutes you require
# MIN =
Example # MIN = 001 # This will turn on the relay for 1 minute.
Example # MIN = 060 # This will turn on the relay for 60 minutes.
Example # MIN = 120 # This will turn on the relay for 120 minutes.
The maximum number of minutes is 999.
You will receive a text acknowledgment “TIMER SET”
The timer will stay on for the preset time and then turn itself off. If you wish to cancel the timer
before the preset time has expired you can do this by texting
# MIN = 000 # this will cancel the time.