Page 2 of 4
Installation & Operating Instructions
Please read these instructions before use
Models:
IRBC-12 & IRBC-24
12V and 24V
Remote Brake Controllers
Installation :
1. Disconnect the vehicle’s NEGATIVE battery terminal.
2. Determine a suitable mounting location inside the cabin. The unit must be mounted securely to a solid
and rigid surface.
3. Hold the main unit in the selected position and mark the hole location through the holes in the flanges of
the unit.
4. Using a suitable drill bit, drill holes in the marked locations.
5. Secure Main unit in position with self tapping screws being careful not to strip the holes by
over-tightening.
6. Drill a hole for the 8.5mm Shaft in a suitably sized mounting panel in the dash with a wall thickness of
less than 4mm.
7. Affix decal and locking nut over shaft and tighten. Turn shaft fully counter clockwise and affix the knob
on the shaft with firm even pressure with the indicator facing the minimum position.
8. Plug the RJ45 connector on remote cable into main unit.
9. Connect brake wiring as per wiring instructions and follow Set-up and Operation procedures.
Note :
The IRBC-12 and IRBC-24 are load activated and can not be tested without load. At no load, output
reading of high voltage will register. Also the output voltage is PULSED, so it cannot be measured
with a volt meter or test light.
IRBC-r3
Unit 2, 110 Station Road, Seven Hills ,NSW, 2147, Australia
Page 2 of 4
Wiring Diagram
To Remote Control
BLACK
BLUE
WHITE
RED
To Vehicle Brake Switch (Cold Side)
Or source that is pure DC when vehicle brake lights are on.
Note: Only Activated by Positive feed.
Earth
To Trailer Brake Coils.
Fuse must be fitted (Not Supplied)
To Positive Voltage Feed
i.e Battery Positive
