1. Usage
USAGE
A. Connect cables to PROTEK M733
B. Push the "power On/Off" button
C. Initialize PROTEK M733 by pushing the "Zero" button before the input RF signals.
D. The default unit is mW. To use other units, please push the "UNIT" button
E. Refer to Figure 3 about LCD output information
F. If the measured data in mV are higher than 1999, a dot between the first two digits
will blink. For example, if the measured value is 2500mV, then 250 will be displayed
and a dot will blink between 2 and 5 so users can treat this 2.5V or 2500mV.
G. If the input RF signals are over 500mW, then HPI (High Power Input) alarm will be
displayed irrespective of the measured data.
