
6
Humidistat-Thermostat
GENERAL INSTALLATION
INSTALLATION INSTRUCTIONS
Figure 1: 24" is the approximate distance from the edge of the transition to the edge of the humidistat installation.
1. The Humidistat-Thermostat should be
mounted on the side of the bin wall between the
foundation and the drying floor. It should be
installed approximately 24" from the right side of
the transition as shown.
3. Caulk the top and sides of the plastic housing
using roll caulking supplied with the unit. Do
not caulk the bottom side of housing so mois
ture can escape.
4. Carefully insert sensing probes through bin wall
and secure housing to wall using self-drilling
screws provided. Be careful not to overtighten
screws. Damage to housing could result.
5. Make wiring connections to heater as shown
in heater owners manual.
Standard electrical safety practices and codes should
be used when installing the Humidistat-Thermostat.
Refer to the National Electric Code Standard
Handbook by the National Fire Protection Asso-
ciation.
A qualified electrician should make all
wiring installations.
ALWAYS DISCONNECT
AND LOCK OUT POWER
BEFORE WORKING ON OR
AROUND HEATER
2. Use the template on page 17. With these
instructions, drill only the holes necessary for
your particular model. (Note: For humidistat to
operate properly optional cutout must be used.)
Summary of Contents for PNEG-236
