17
Assembly
PNEG-1391 8",10", & 12" BE-SAW Augers
F. Using a 3/8" x 3" long (grade 5) hex head capscrew and nylon locknut, attach the u-joint to the incline
tail stub.
G. Slide the lower end of the inclined flighting
(the end with the u-joint fastened)
down into the upper end of
the incline tubing. Slide the flighting down until the u-joint is near the swing-away hopper bearing stub.
H. Connect the u-joint on the flighting to the bearing stub in the swing-away hopper using a 3/8" x 3" long
(grade 5) hex head capscrew and nylon locknut.
I.
Bolt hinged cover to the front of the swing-away hopper using two (2) 5/16" x 3/4" long (grade 5) hex
head capscrews, flat washers, and nylon locknuts.
J. Install cover strap over lid onto the 3/8" stub that is welded to the box on the lower end of the incline
tube. Use the 3/8" nylon locknuts to hold the straps onto the stub.
DO NOT tighten the nuts down. The hinged cover MUST be able to slide un-
der the strap when the incline tube is tilted at different angles.
FIG. 2-C
5/8" LOCKNUT
INCLINE FLIGHT
STOP RING
RING
INCLINE TUBE
FLAT WASHER
3/8" X 1 3/4" LONG
(GRADE 5) HEX
HEAD CAPSCREW,
FLAT WASHER AND
LOCKWASHER
19/32" LONG
SPACER
BUSHING
5/8" X 3-1/2" (GRADE 5)
HEX HEAD CAPSCREW
12" Standard Profile Hopper Assembly
2. ASSEMBLE 12” HOPPER AND IN- LINE TUEBE ASSEMBLY (CONT.)
Summary of Contents for PNEG-1391
