GSi Cumberland PNEG-1333, Installation And Owner'S Manual

Page: 32 / 68

4. Assembly
32 PNEG-1333 Turkey Poult Feeder System
Shocker Wire Installation
1. Double wrap the shocker wire around the first insulator at the boot end of the feed line and secure
with the cable sleeves provided.
2. Thread the shocker wire through the cable guides on top of the drop tubes as shown in Figure 4AO .
3. Attach the wire tension spring to the next insulator and loop the shocker wire through the spring
eyelet. Pull the shocker wire with enough force to stretch the spring 3/4"-1" (19.1 mm-25.4 mm).
Secure the shocker wire with the supplied cable sleeve as shown in
Figure 4AP . Cut the wire with
enough excess to use as a jumper to carry current to the next section of shocker wire. This is done
by running the excess wire through the center of the spring, over the insulator and connecting it to
the next section of shocker wire with the supplied cable sleeve.
Figure 4AO Figure 4AP
Ref # Description
A Insulator