7. Installation
PNEG-250
Hi-Lo and PRO-1 Pan Feeders
77
Power Winch Instructions
Mounting Winch Assembly
1. Cut one length of 2 x 10 and one length of 2 x 4 long enough to span three (3) ceiling purlins.
These will be used to support the winch assembly.
2. Using the winch assembly as a template, pre-drill the 2 x 10 (C) and 2 x 4 (B) as shown in
3. Insert carriage bolts (A) (not supplied) down through winch supports and through winch assembly
(D). Tighten winch support bolts.
4. Mount the winch supports securely to the ceiling purlins. BE SURE WINCH SUPPORTS SPAN
THREE (3) PURLINS. Winch cable drum must be centered through the centerline of the main cable
run as shown in
Figure 7DQ
Figure 7DR
Winch Cable Assembly
1. Winch system is designed to operate using a block and tackle system. Two (2) 3-1/2" master
pulleys, 3/16" cable and cable clamps are required to complete block and tackle cable loop.
Figure 7DS
Ref #
Description
Ref #
Description
A
3/8" x 2-1/2" Carriage Bolt
D
Winch Assembly
B
2 x 4 Lumber
E
Centerline of Winch Drum
C
2 x 10 Lumber
F
Centerline of Main Cable Run
