GSi 21' Diameter Gamma, Assembly Instructions Manual

Page: 21 / 38

4. Roof Assembly
PNEG-2145 21' Diameter Gamma Roof Assembly Instructions 21
Attaching the Center Collar to Peak Ring Weldment
The center collar assembly is a three (3) piece design and attaches to the peak ring weldment using the
Z-collar support clips (D).
1. Position the Z-collar center collar support clips (D) on to the peak ring weldment as shown in
Figure 4G.
2. Install the flange bolts (B) and flange nuts (C), securing the Z-collar support clips (D) to peak ring
weldment (A).
Figure 4G Assembling the Z-Collar Support Clips
3. Place the three (3) center collar (E) pieces over the Z-collar support clips (D) and secure the center
collar pieces (E) together using flange bolts (B) and flange nuts (C) as shown in Figure 4H.
NOTE: Make sure center collar (E) is free to move for adjustment on the Z-collar support clips (D) to
align with the roof flashing holes.
Figure 4H Attaching the Center Collar to
Peak Ring Weldment
Ref # Part # Description
A CRP-7299 Peak Ring Weldment
B S-10260 5/16" x 1" Flange Bolt
C S-3611 5/16" Flange Nut
D CRP-4900 Z-Collar Support Clip
Ref # Part # Description
A CRP-7299 Peak Ring Weldment
B S-10260 5/16" x 1" Flange Bolt
C S-3611 5/16" Flange Nut
D CRP-4900 Z-Collar Support Clip
E CRP-4608 Center Collar