GSI Group PNEG-1813, Installation And Operation Manual

Page: 31 / 58

3. Operation Procedures
PNEG-1813 Electronic Distributor Control 31
3. Operation Procedures
Initializing Screen
When powering up the distributor the first screen that appears is the “Initializing” screen (See Figure 3A.)
Press “OK” to proceed to the “Main” screen. See “Main Screen” on page 31.
NOTE: Pressing “OK” button after first time power up after a retrofit will bring you to the configuration
screen.
Figure 3A Help Menu
NOTE: The following screens are taken from various models of distributors, which may result in
differences between this manual and that of your actual display.
Main Screen
Depending on the number of spouts in your current configuration, one of the following screens will be
displayed
(See Figure 3B.) The name of the current spout is indicated at the top of the screen, and is
indicated in the graphic with a green circle. At the bottom of the screen are three buttons to navigate to
either the Help Menu, Move Screen, or Setup Menu.
Figure 3B
4-Spout
Main Screen
6-Spout
Main Screen
8-Spout
Main Screen
10-Spout
Main Screen
BIN 1
CURRENT SPOUT SELECTION: CURRENT SPOUT SELECTION:
BIN 1
BIN 1
BIN 1
CURRENT SPOUT SELECTION:
CURRENT SPOUT SELECTION: