GSI Group PNEG-1445, Assembly & Operation Manual

Page: 29 / 60

PNEG-1445 6", 8", 10", & 12" Custom Augers 29
4. ASSEMBLY
D. Place Intake Guard Half Band above the lower half band on the Intake Guard and
attach using proper hex bolts and Nylock nuts. (See Chart Above) , (See Figure 4Y) .
Figure 4Y
Assembling the Inlet Hopper with Bearings for All 6", 8", 10" & 12"
Custom Augers
16. Installing Intake Shaft
A. Begin by assembling the intake shaft to the flight using the required Grade 8 bolts
and stover nuts. (See Chart for Bolt Sizes) , (See Figure 4Z) .
Figure 4Z .
Flight Hardware
6" 3/8" - 16 x 2" Grade 8 Hex Bolts
8" 7/16" - 14 x 3" Grade 8 Hex Bolts
10" 1/2" - 13 x 3-1/2" Grade 8 Hex Bolts