GSI Group 890-00584, Installation And Configuration Manual

Page: 50 / 120

Chapter 8: Configuring a Temperature Zone
Figure 8-3 Graph showing a zone in an alert state followed by a 10 second recovery time
TEMPERA TURE
RECO VERY TIME = 10 SECONDS
TIME
(SECONDS)
ALERT 2
HIGH ALERT
THRESHOLD
INDOOR
T° READING
LOW ALERT
THRESHOLD
10 20 30 40 50 60
8 SECONDS
BELOW HIGH
THRESHOLD
ALERT 1 NO ALERT
RECOGNITION TIME = 0 SECONDS
14 SECONDS BEL OW
HIGH THRESHOLD
ALERT 1 IS
RESET AFTER
10 SECONDS
HIGH T° SETTING
LOW T° S ETTING
10 SECONDS
Activating the Temperature Curve
The temperature maturation curve allows you to monitor a temperature zone where the temperature is
expected to gradually decrease over a period of days.
1. In edit mode, under the Limits tab, click on the T° curve button.
NOTE: The temperature maturation curve is only available in temperature zones.
2. If you want a temperature maturation curve different than Default , press on the curve selection
button to display the selection list
3. Click on the circle to the left of the desired temperature maturation curve.
4. Click on the edit field next to the High Offset to display the input keypad and enter the high offset
value.
5. Click on the edit field next to the Low Offset to display the input keypad and enter the low offset
value.
6. If you want an age value different than 1 , select the Age (days) field to display the input keypad.
7. Select the starting day for your temperature maturation curve.
50 895-00677 Agri Alert 128 Touch