Hui Zhou Gaoshengda Technology Co., LTD
WXT2AM2101
PAGE 3 OF 4
Version 1.0
The module is limited to OEM installation ONLY.
The OEM integrator is responsible for ensuring that the end-user has no manual instruction
to remove or install module.
The module is limited to installation in mobile application.
A separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and difference antenna configurations.
There is requirement that the grantee provide guidance to the host manufacturer for
compliance with Part 15B requirements.
The module complies with FCC Part 15.247 / Part 15.407 and apply for Single module approval.
Trace antenna designs: Not applicable.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20cm
between the radiator & your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
The device
must be professionally installed The intended use is generally not for the general public.It is generally for
industry/commercial use.The connector is within the transmitter enclosure and can only be accessed by disassembly of the
transmitter that is not normally required. the user has no access to the connector. Installation must be controlled. Installation
requires special training This module has been assessed against the following FCC rule parts: CFR 47 FCC Part 15 C
(15.247, DTS and DSS) and CFR 47 FCC Part 15 E (NII). It is applicable to the modular transmitter
。
This radio transmitter 12290A-WXT2A has been approved by Innovation, Science and Economic
Development Canada to operate with the antenna types listed below, with the maximum permissible
gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain
indicated for any type listed are strictly prohibited for use with this device.
Le présent émetteur radio 12290A-WXT2A a été approuvé par Innovation, Sciences et Développement
économique Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain
admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain est supérieur au
gain maximal indiqué pour tout type figurant sur la liste, sont strictement interdits pour l'exploitation de
l'émetteur.
The concrete contents to check are the following three points.
１
)
Must use following one antenna.
２
)
Should be installed so that the end user cannot modify the antenna;
３
)
Feed line should be designed in 50ohm
Fine tuning of return loss etc. can be performed using a matching network.
Le contenu concret à vérifier sont les trois points suivants.
１
) Une des trois antennes suivantes doit être utilisée.
２
) doivent être installés de façon que l'utilisateur final ne peut pas modifier l'antenne
３
) La ligne d’alimentation doit être conçue en 50ohm
Le réglage précis de la perte de rendement, etc. peut être effectué en utilisant un réseau correspondant.
For devices with detachable antenna(s), the maximum antenna gain permitted for devices in the band 5725-5850 MHz shall
be such that the equipment still complies with the e.i.r.p. limits as appropriate;
If the module intended to installed to a protable devices, a permissive change may need before used.