HT G11 / G12 GSM Terminal Instruction Manual
8
2. INSTALLATION INFORMATION
2.1 Installation Information
1.
Secure the device to a suitable place in the panel. (Suitable for rail
mounting)
2.
Make a supply connection to terminal named “AC 85/265 V” or “DC
10/30 V”. Make sure that there is no power in the cables in the
meanwhile.
WARNING! If AC voltage is applied to the devices with DC supply, the
device is out of warranty.
Connection between the device to be communicated:
a.
Electric Meter / Optical Port: See. Figure 3.1
b.
Electric Meter / RS-232: See. Figure 3.3
c.
Electric Meter / RS-485: See. Figure 3.4; 3.5; 3.6; 3.7; 3.8; 3.9
d.
Modbus Device (Relay, analyzer etc.) / RS-485: See. Figure 4.1; 4.2
3.
Cancel the PIN code of the SIM card and insert into the SIM card slot as
shown on the device.
4.
Operate the device by energizing after checking all the connections for the
last time.
5.
After a while, by entering SmartPower Energy Monitoring System, you
can check whether your device is sending data or not. If you have no
internet access in the field, you can get help from our technical support
line.
NOTE
1.
If the GSM signal power is insufficient, disassemble the whip antenna on
the device and assemble a wired antenna instead.
2.
If more than one meter is to be connected via RS-485, the technical
support line must be called, and serial numbers of the meters must be
defined to the system.
