ķ
20
Installation and Removal
A 5
+12 V switching voltage output
(max. 0.5 A)
on blade contact A 5 when the radio is
switched on.
For automatic aerial (extend/retract),
aerial amplifier (operating voltage) etc.
A 4
+12 V ignition voltage
Connect to terminal 15 if you wish to switch
the car radio on and off with the ignition/start
switch.
The A4 blade contact may also remain free.
In this case, the car radio must always be
switched on and off with the
¡
IO
button.
In addition, the car radio is not automatically
switched off after 1 hour if the ignition is off.
The Security LED does not flash.
A 2
Phone mute connection
for car telephone or CB radio.
The car radio is “muted” when the car tele-
phone or CB radio is in operation.
The display indicates "
PHONE
", see page 16,
EXPERT settings.
For this, the blade contact A 2 must be
connected from the mute output of the tele-
phone/CB radio to earth!
Loudspeakers
Blade contacts B: Figure
+
Maximum output power
with 4
Ω
loudspeakers: 4 x 20 W.
Front speakers
Rear speakers
B 3
right-hand
+
B 1
right-hand
+
B 4
right-hand
–
B 2
right-hand
–
B 5
left-hand
+
B 7
left-hand
+
B 6
left-hand
–
B 8
left-hand
–
í
Do not electrically connect the speaker
contacts to each other and do not
connect them to earth.
Additional connections
Blade contacts C: Figure
+
CD changer (AUX connection )
C 13
CD bus control line.
For AUX mode,
connect with C15.
C 15
CD bus, earth.
C 16
+12 V supply voltage for CD changer.
C 17
Switching voltage for CD changer.
C 18
CD-AF/AUX-AF, earth.
C 19
CD-AF/AUX-AF, left.
C 20
CD-AF/AUX-AF, right.
C 7
for service only
C 9
for service only
í
The contacts C7 and C9 must remain
free.
