EN
GLISH
27
Access control for CI module and smart card
See the section in the “Common Interface operation” chapter on
page 33.
Displaying signal information
1
Select »Signal Information« with »
Λ
« or »
V
« and press »
OK
« to
confirm.
– You will see information on the channel, modulation, quality
and signal strength.
Notes:
The lower section of the menu shows the signal properties. The
further the bar for »Quality« and »Signal Strength« extends to
the right, the better the reception signal.
The signal level not only depends on your receiver system, but
also on the channel which is currently active. Remember this when
aligning your antenna using the signal level display.
2
Press »
EXIT
« to end the display.
Updating software
1
Select »Software Upgrade« with »
Λ
« or »
V
« and press »
OK
«
to confirm.
2
Select »Auto Upgrade« with »
Λ
« or »
V
« and press » « or » «
to select »On«.
– The software is updated automatically, if possible
or
Select »Search for New Software« with »
Λ
« or »
V
« and press
»
OK
« to confirm.
– The device searches the existing channels for new software.
3
Press »
EXIT
« to end the setting.
Displaying the software version
1
The »Version« line shows the software version.
2
Press »
EXIT
« to end the display.
V
Λ
CONVENIENCE FUNCTIONS
------------------------------
Back
Exit
EXIT
SIGNAL INFORMATION
Channel
34 (578 MHz)
Modulation
8K 16QAM R2/3 G1/4
Quality
Good
Signal Strength
Good
100 %
98 %
SOFTWARE UPGRADE
1.1.4
Version
Search for New Software
Auto Upgrade
Off
Select and Change
Back
Exit
EXIT
IDTV FUNCTIONS
No CA-Module
1.1.4
Version
Software Upgrade
Signal Information
CA - Module
Parental Control
Time Settings
Language Settings
Select and Open
Back
Exit
EXIT
