62
•
•
In case the hose is elevated
after laying it on the floor level
or close to the ground (less than
40 cm above the ground), water
discharge becomes more difficult
and the laundry may come out
excessively wet. Therefore, follow
the heights described in the
figure.
100cm
40cm
•
•
To prevent flowing of dirty water
back into the machine and to
allow for easy discharge, do not
immerse the hose end into the
dirty water or do not drive it in the
drain more than 15 cm. If it is too
long, cut it short.
•
•
The end of the hose should not
be bent, it should not be stepped
on and the hose must not be
pinched between the drain and
the machine.
•
•
If the length of the hose is too
short, use it by adding an original
extension hose. Length of the
hose may not be longer than 3.2
m. To avoid water leak failures,
the connection between the
extension hose and the drain
hose of the product must be fitted
well with an appropriate clamp as
not to come off and leak.
Adjusting the feet
A
WARNING: In order to
ensure that the product
operates more silently
and vibration-free, it must
stand level and balanced
on its feet. Balance the
machine by adjusting the
feet. Otherwise, the product
may move from its place
and cause crushing and
vibration problems.
•
*
Loosen the lock nuts on the feet
by hand.
•
*
Adjust the feet until the product
stands level and balanced.
•
*
Tighten all lock nuts again by
hand.
A
WARNING: Do not use any
tools to loosen the lock
nuts. Otherwise, they will
get damaged.
