Grundig GTN 38240 GC, User Manual

Page: 11 / 36

11 / 36 EN
Dryer / User Manual
Installation
Connecting the water drain hose
1. Pull hose in the product by hand in
order to disconnect it from where it
is connected. Do not use any tools to
remove the hose.
2. Connect one end of the drain hose
supplied separately with the product to
the connection point from where you
removed the hose of the product in
previous step.
3. Connect the other end of the drain hose
directly to the wastewater drain or to the
washbasin.
A
CauTION:
Hose must be secured in
every type of connection. Your house
will be flooded if the hose comes
loose during water discharge.
C
Attach the water drain hose to a
height of maximum 80 cm.
C
Make sure that the water drain hose
is not stepped on, twisted or bent
between the drain and the machine.
3.3 under counter installation
ƒ
This product can be installed under a
counter if the height of the counter is
sufficient.
ƒ
Leave at least 3 cm of space around the
sides and the rear wall of the product
when installing it under a counter or in a
cupboard.
3.4 mounting over a washing
machine
ƒ
A fixing device should be used between
the two machines when installing the
dryer above a washing machine.
ƒ
Total weight of the washing machine
and the dryer -with full load- when they
are placed on top of each other reaches
to approx. 180 kilograms. Place the
products on a solid floor that has sufficient
load carrying capacity!
3.5 Connecting to the drain
In products equipped with condenser unit,
water accumulates in the water tank during the
drying cycle. You should drain accumulated
water after each drying cycle.
You can directly drain accumulated water
through the water drain hose supplied with the
product instead of periodically draining the
water collected in the water tank.