Grundig GKPN 66830LXP, User Manual

Page: 13 / 208

14
4.1.Appropriate
Installation Location
Contact an Authorized Service
for the installation of the product.
In order to prepare the product
for use, refer the information in
the user manual and ensure that
electrical installation and water
installation are appropriate. If not,
call a qualified electrician and
technician to have any necessary
arrangements carried out.
B
WARNING:
Manufacturer
shall not be held liable for
damages that may arise
from procedures carried
out by unauthorized
persons.
B
WARNING:
Product
must not be plugged
in during installation.
Otherwise, there is the
risk of death or serious
injury!
A
WARNING:
If the door
clearance of the room
where the product shall
be place is so tight to
prevent passing of the
product, remove the door
of the room and pass the
product through the door
by turning it to its side;
if this does not work,
contact the authorized
service.
Read the “Safety Instructions” section first!
4. Installation
•
Place the product on an even
floor surface to prevent jolts.
•
Install the product at least 30
cm away from heat sources
such as hobs, heater cores and
stoves and at least 5 cm away
from electrical ovens.
•
Product must not be subjected
to direct sun light and kept in
humid places.
•
Appropriate air ventilation must
be provided around your product
in order to achieve an efficient
operation. If the product is to be
placed in a recess in the wall,
pay attention to leave at least 5
cm distance with the ceiling and
side walls.
•
Please provide at least 5cm
distance for air circulation
between the back side of your
product and the wall to avoid
condensation on the rear panel
of product.
•
Your product requires adequate
air circulation to function
efficiently. If the product will be
placed in an alcove, remember
to leave at least 5 cm clearance
between the product and the
ceiling, rear wall and the side
walls.
•
If the product will be placed in
an alcove, remember to leave at
least 5 cm clearance between
the product and the ceiling,
rear wall and the side walls.
Check if the rear wall clearance
protection component is present
at its location (if provided with