POWER SUPPLY
12
CDP 410/440 page 12
GB
Batteries
• Open the battery compartment and insert as
indicated two alkaline batteries type LR6, AM3,
AA or insert two rechargeable Nickel-Cadmium
batteries .
• Remove the batteries if they are empty or if the
CD player is not to be used for a long time.
The display indicates when the battery voltage is
too low:
• When the indicator
flashes, the batteries
are getting too weak.
• When
appears continuously, the battery
voltage is too low and the CD player will soon
shut down.
Note:
The battery supply is switched off when the
DC IN 6.0 V
socket is in use.
When changing over to battery supply, pull out the
plug from the
DC IN 6.0 V
socket.
Mains adapter (supplied)
1
Make sure that the local voltage corresponds to
the voltage of the adapter.
2
Connect the supplied mains adapter (6.0 V/450 mA
Direct Current plus-pole to the centre pin) to the
player's
DC IN 6.0 V
jack and to the wall outlet.
• Always disconnect the adapter if you are not
using it.
Note:
The CD-player remains connected to the
mains even when it is switched off.
The unit is only fully isolated from the mains if the
mains adapter is removed from the wall socket.
LINE
OUT
CD IN
(AUX, LINE IN)
LINE OUT
DC IN
-<+
6.0 V
LINE OUT
Note on Environmental Protection
Do not throw exhausted batteries in
the household refuse.
Hand over the old batteries to your
dealer or public collecting points when
buying new ones.
DAS
TRACK
MIN
SEC
3 mm
min
Recharging Nickel-Cadmium batteries
(size AA)
Your mains adapter also works as a charger.
This is only possible with
Ni-Cd
batteries
(size AA)
1.2 V/600mAh
.
Note:
As a quick reference when buying the Ni-Cd
batteries, be sure that the metal cap on the nega-
tive pole is exposed more than 3 mm as illustrated.
• Charge the batteries prior to first use and also if
the batteries have not been used for a long
period.
• Install the rechargeable batteries in the battery
compartment as described before.
• Connect the AC adapter to the CD-player and
then to the wall outlet.
• The batteries should be allowed to recharge for
8 hours for full capacity.
• The ambient temperature for recharging should
be between 5˚C and 40˚C.
• The player can be operated while the batteries
are being recharged.
Line out
Reproduction through a stereo system
• Turn down the volume of your stereo system.
• Connect a signal lead to the
LINE OUT
jack of
the CD player and to the input jacks
CD IN
,
AUX
(iliary) or
LINE IN
of the other set (amplifier,
receiver, radio cassette recorder etc.).
• Adjust the sound with the controls of the stereo
system.
