Grundig BLUEBEAT GSD 300, Instructions Manual

Page: 7 / 11

7­
ENGLISH
Connecting­the­power­adapter
Note:­
7
Check that the mains voltage on the power
adapter corresponds to your local mains
supply.
If this is not the case, contact your spe-
cialist dealer.
1
Connect the single plug of the power adapter
into the »
DC­IN­12­V
« socket.
2 Connect the power adapter into the wall sock-
et.
Caution:
7
The device is connected to the mains with
the power cord. Pull out the power adapter
if you want to completely disconnect the de-
vice from the mains.
7
Make sure the power adapter is easily ac-
cessible during operation and not hindered
by other objects.
Activate­the­remote­control­
battery
1
Remove protection film from the battery com-
partment.
– The remote control is now functional.
Change­remote­control­­
battery­(Type­CR­2025)
Note:
7
If your device no longer responds to the
remote control commands, the battery may
be dead. It is imperative that dead batteries
be removed. We do not assume liability for
damage caused by leaked batteries.
Caution:
7
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent
type.
1 Hold the remote control with the back side fac-
ing up.
2
Unscrew safety bolt of the battery holder and
remove the battery holder.
CONNECTION­AND­PREPARATION
­____________________
3 Insert the battery with the positive pole facing
upwards.
4
Push battery holder into the remote control until
it clicks into place.
5 Screw in the safety bolt.
Charging­external­device
Note:­
7
Switch the device off before you connect
external devices.
1 Place the external device carefully on the
» Micro­USB « charging plug;
or
pull out the charging plug carefully and con-
nect it to the micro USB socket of the external
device.
Note:­
7
Pull out the holder sufficiently far so that the
external device can be stored.
2
When the external device is charged, pull out
the plug, pull on the charging plug gently and
the cable retracts automatically.
Connecting­external­devices
Note:­
7
Switch the device off before you connect
external devices.
1
Use a standard audio adapter to connect
the audio outputs of the external device
to the »
AUX­ IN
« (ø 3.5 mm) socket of the
GSD 300.