34
Inserting a memory card
The device supports SD and MMC memory cards.
1
Switch off the device.
2
Insert the card carefully into the card slot »
SD/MMC
« (in the CD compartment) with the
contacts facing downwards until it latches into place.
Caution:
– Do not use excessive force when inserting the card. Only apply slight pressure.
– The memory cards are resistant to dirt and moisture, but must only be inserted into the
device in a dry and clean condition.
– Never remove memory cards during operation. This can damage the memory card.
This type of damage will invalidate your warranty.
Removing a memory card
1
Switch off the device.
2
Press the card inwards slightly until the latch is released. Then pull out the card.
Activating the remote control battery
1
Activate the remote control battery by pulling on the film protruding from the battery
holder.
Changing the batteries
1
Pull out the battery holder.
2
When inserting the battery (3 V, lithium), make sure the positive terminal (+) is facing
upwards and the buttons on the remote control are facing downwards (see battery icon
on the bracket).
3
Push the battery holder back into the remote control until it latches into place.
Note:
If the device no longer reacts properly to remote control commands, the battery may be
flat. Always remove used batteries. The manufacturer accepts no liability for damage
caused by leaking batteries.
Environmental note:
Batteries, including those which contain no heavy metals, may not be disposed of with
household waste. Please dispose of used batteries in an environmentally sound manner.
Find out about the legal regulations which apply in your area.
CONNECTION AND PREPARATION
___________
