Grundfos TPE Series, Instructions Manual

Page: 11 / 68

English (GB)
11
4. Electrical connection
Carry out the electrical connection according to local
regulations.
Check that the supply voltage and frequency
correspond to the values stated on the nameplate.
5. Setting via the control panel
6. Working on the product
6.1 Megging
7. Further product information
Use either the QR code or the web address below to
access the complete installation and operating
instructions for the relevant product.
TPE, TPED Series 2000 pumps
grundfos.com/TPES2000-manual
8. Disposal
This product or parts of it must be disposed of in an
environmentally sound way:
1. Use the public or private waste collection service.
2. If this is not possible, contact the nearest
Grundfos company or service workshop.
The waste battery should be disposed of through the
national collective schemes. If in doubt, contact your
local Grundfos company.
Subject to alterations.
Warning
Before making connections in the
terminal box or breaker cabinet, make
sure that the power supply has been
switched off for at least 5 minutes.
Make sure that the power supply
cannot be accidentally switched on.
The product must be connected to an
external all-pole mains switch
according to local regulations.
The product must be earthed and
protected against indirect contact in
accordance with local regulations.
If the power supply cable is damaged, it
must be replaced by the manufacturer,
the manufacturer’s service partner or a
similarly qualified person.
Warning
The product may be so hot that only
the buttons should be touched to avoid
burns
Warning
Before fitting add-on modules, making
connections in the terminal box or
breaker cabinet or starting fault
finding, make sure that the power
supply has been switched off for at
least 5 minutes. Make sure that the
power supply cannot be accidentally
switched on.
Caution
Megging of an installation
incorporating MGE motors is not
allowed, as the built-in electronics may
be damaged.
TM
05 868
8 261
3